The maintenance of the machine is a very important regular work, it should be closely with the operation and overhaul, and so on, should be full-time personnel on duty inspection.
The bearing of the Crusher bears the whole load of the machine, so good lubrication has a great relationship with the bearing life, it directly affects the service life and operating rate of the machine, so the injection of lubricating oil must be clean, the seal must be good, the main injection of this machine ⑴ rotational bearing ⑵ roll bearing ⑶ all gear ⑷ active bearings, sliding plane.
The newly installed tyre is prone to loosening and must be inspected frequently.
Pay attention to the work of all parts of the machine is normal.
Pay attention to the wear of wearing parts, always pay attention to the replacement of worn components.
The base plane of the movable device shall be out of the dust and other things so as not to be able to move the movable bearings on the base of the machine.
The bearing oil temperature rises, should immediately stop the inspection reason to eliminate.
If the rotating gear is running, the sound of the impact should be stopped immediately to check and eliminate.
The equipment should be installed on the level of concrete foundation, with anchor bolts fixed.
The installation should pay attention to the host body and horizontal vertical.
After installation check all parts of the bolts are loose and the main cabin door is tight, such as please to tighten.
Configure the power cord and control switch according to the power of the device.
Check finished, carry out the air load test, the normal test can be produced.